Alignment of fiber optic transmitter LED inside housing

General topics forum; please ensure your post follows the forum rules.

Alignment of fiber optic transmitter LED inside housing

Postby Tunes » Sun Jun 19, 2016 6:55 pm

I had to Des older the LED transmitter on the SD interrupter board as the lens of the emitter wasn't aligned within the housing after it was already soldered to the board. Make sure you adjust the position of the emitter in the housing so it can be seen coaxial with the housing before soldering!!
Tunes
Rambunctious Relay
 
Posts: 38
Joined: Sat May 07, 2016 6:50 am

Return to Anything else for discussion?

Who is online

Users browsing this forum: No registered users and 4 guests