w00t!!
Posted: Sun Dec 01, 2013 3:29 pm
Got it running!
Problem #1 was an empty Atmel. A replacement one sent by the team, solved my problem with the interrupter.
Problem #2 was blowing up fuses. It turned out to be a case of PEBKAC. After ordering some replacement MU460's and IGBT's, I got it working at low power, but not great.
Then I went from 6 to 5 primary windings and the output was much better. Haven't tested the coil at more than 50% output, but it's already pretty spectacular as it is!!
http://youtu.be/5lXNuDvndbw
Problem #1 was an empty Atmel. A replacement one sent by the team, solved my problem with the interrupter.
Problem #2 was blowing up fuses. It turned out to be a case of PEBKAC. After ordering some replacement MU460's and IGBT's, I got it working at low power, but not great.
Then I went from 6 to 5 primary windings and the output was much better. Haven't tested the coil at more than 50% output, but it's already pretty spectacular as it is!!
http://youtu.be/5lXNuDvndbw