Works as expected!

Show off your finished kit here!

Works as expected!

Postby jmeckstroth » Mon Oct 20, 2014 7:00 pm

My oneTesla assembled and works fine thus far. Only changes I made:

1) added a finger guard to the fan
2) added a clear acrylic tube over the secondary coil to overcome some arcing with the primary (even though I put three coats of poly on the secondary coil windings.
3) I also brought out a ground wire from the case to connect to a metal mesh door screen guard that I use as a ground plane, connected via an in-line connector.

Thanks, Jim M
Last edited by jmeckstroth on Fri Nov 28, 2014 9:54 pm, edited 1 time in total.
Tipsy Toggle Switch
Posts: 1
Joined: Sun Jun 15, 2014 7:44 pm

Re: Works as expected!

Postby Alex » Thu Oct 23, 2014 9:08 am

i found the fan guard useful as well. The rosewell fans were extremely sharp, and I've gotten very deep cuts twice already :P
Incredible IGBT
Posts: 627
Joined: Sun Jan 13, 2013 12:16 pm

Return to Completed oneTesla Kits

Who is online

Users browsing this forum: No registered users and 2 guests