oneTesla OCD!
Posted: Tue Sep 02, 2014 5:34 pm
Hi everyone!
If anyone wants over current detection for their oneTesla coil, I've made a little PCB that does it.
It connects using 4 wires (+5V, GND, Input, and Output) and a current transformer. To install it, you just need to desolder a resistor and solder the 4 wires from the board, and install the current transformer over the primary wire.
If anyone is interested, they are $30+shipping. If you have any questions, feel free to ask!
~Alex
If anyone wants over current detection for their oneTesla coil, I've made a little PCB that does it.
It connects using 4 wires (+5V, GND, Input, and Output) and a current transformer. To install it, you just need to desolder a resistor and solder the 4 wires from the board, and install the current transformer over the primary wire.
If anyone is interested, they are $30+shipping. If you have any questions, feel free to ask!
~Alex