Connecting secondary.

Got friendly advice? Post it here!

Connecting secondary.

Postby tsaksa » Fri Oct 11, 2013 11:23 am

Some people mentioned they had difficulty providing a solid electrical connection to the secondary mounting screws from the wire coming off the ends of the secondary. And some also felt the mechanical connection was not as strong as they would like. I made two changes that might help here. I have not yet tested them, but here they are for your consideration.

1. I used a couple of 2 inch strainer end cap to hold the mounting screws to the secondary tube. These caps are available for about $2 at home stores.
1011130650.jpg
(116.18 KiB) Downloaded 248 times


2. I also cut a piece of brass shim stock to run through the hole on the tube, and bending it all the way around the inside of the hole. When the screw in inserted it fits tightly and you actually need to screw it into place. It seems like there is no way it would not have a solid electrical connection with the screw, and provides a convenient tab to solder the secondary wire to.

1011130651.jpg
(102.7 KiB) Downloaded 248 times


1011130653a.jpg
(105.22 KiB) Downloaded 248 times


This collection then gets hot glued onto the secondary and seems to provide a very good mechanical and electrical connection. I lined the tab up with the end of the wire as I glued it, and later soldered it to the wire. The coil reads a solid 228 ohms now. I still plan to glue the other disks over this one to provide an even more solid connection. Again, not tested, but I do not know why it would not work. There is also no reason this technique could not be used with just the standard end plates if you felt those were solid enough. You do need slightly longer screws, but I am using stainless steel to reduce any magnetic interference.
tsaksa
Rambunctious Relay
 
Posts: 33
Joined: Fri Oct 11, 2013 10:27 am

Return to Tips and Tricks

Who is online

Users browsing this forum: No registered users and 1 guest