My coil is now working moderately well (about 18" arcs) and playing polyphonic music. See the movie at http://www.shustek.com/teslacoil/OneTesla_10Apr2014.wmv and the attached photo.
At first I had a wimpy arc and blew the IGBTs. My secondary is 240 ohms and resonates with a signal generator at 293 KHz. The primary was 6 turns and resonated at 254 KHz, which was too low. And at moderate power they seemed to be way too far apart: 312 KHz and 238 KHz, respectively. So I raised the primary resonant frequency by changing to 5 turns, and the result is what you see. I can run at max power with no ill effects. I suspect some fine-tuning (changing the primary capacitor or using partial turns on the coil) could make the arcs even better.
This is a nice and remarkably simple design! I'm working on a coil twice as large, using more more complicated circuitry and 75-amp IGBTs driving a primary made from 1/4" copper tubing. But I keep blowing the IGBTs there too. Now that I see how critical matching the primary and secondary resonance is, I might be able to get that one running.
-- Len
- It is currently Sat Apr 27, 2024 9:09 pm • All times are UTC - 5 hours
Coil working
3 posts
• Page 1 of 1
Re: Coil working
pictures of the bigger coil? (:
- Alex
- Incredible IGBT
- Posts: 627
- Joined: Sun Jan 13, 2013 12:16 pm
Re: Coil working
Below is a bad photo of my bigger coil. You can also see some videos (before the expensive IGBTs blew!) at
http://www.shustek.com/teslacoil/tesla_20Nov2011_01.wmv and
http://www.shustek.com/teslacoil/tesla_7Dec2011_03.wmv
It started off based on Dan McCauley's "miniBrute" design (http://www.easternvoltageresearch.com/), but then I completely redesigned the IGBT circuits using Avago ACPL-P343 gate drivers and dual independent floating supplies. It's a nice design that doesn't work....yet. It was while I was pondering that I decided to build the oneTesla version.
-- Len
http://www.shustek.com/teslacoil/tesla_20Nov2011_01.wmv and
http://www.shustek.com/teslacoil/tesla_7Dec2011_03.wmv
It started off based on Dan McCauley's "miniBrute" design (http://www.easternvoltageresearch.com/), but then I completely redesigned the IGBT circuits using Avago ACPL-P343 gate drivers and dual independent floating supplies. It's a nice design that doesn't work....yet. It was while I was pondering that I decided to build the oneTesla version.
-- Len
- LenShustek
- Tipsy Toggle Switch
- Posts: 2
- Joined: Tue Mar 18, 2014 12:07 am
3 posts
• Page 1 of 1
Return to Completed oneTesla Kits
Who is online
Users browsing this forum: No registered users and 58 guests