Ground trace burnt from a short, improvised grounding

Show off your finished kit here!

Ground trace burnt from a short, improvised grounding

Postby cynofox » Fri Feb 23, 2018 11:21 pm

Image

I completed my oneTesla TS in 10 hours! From unboxing to first run, did not go to sleep until 3am! I used a heat gun to quickly dry up the varnish so I can apply a second coat... and I'm surprised that I have not had any arcing, yet.

The only issue I had was that the ground wire that is jumped underneath the primary coil started to arc with the primary coil. Burnt half of the trace of the primary. Then I notice there was arcing by the fuse, the whole ground trace was burnt going to the standoff. So I improvised the power cable, solder a ground wire to the ground and put and alligator clip on the other end so I can clip it to the standoff.
Now it works good again, with no arcing!

I also made a 3D printed case for the sd interrupter. I uploaded the file to thingiverse if anybody would like to print it out.
https://www.thingiverse.com/thing:2804399

Image
cynofox
Tipsy Toggle Switch
 
Posts: 2
Joined: Fri Feb 23, 2018 10:32 pm

Re: Ground trace burnt from a short, improvised grounding

Postby Lovreli » Wed Jan 09, 2019 6:55 am

Same thing happened to me, i just run a small ground wire from a plug to the tin foil under the tesla coil
Lovreli
Tipsy Toggle Switch
 
Posts: 9
Joined: Fri Nov 30, 2018 11:12 am


Return to Completed oneTesla Kits

Who is online

Users browsing this forum: No registered users and 1 guest


cron