Success - TinyTesla

Show off your finished kit here!

Success - TinyTesla

Postby jeebwise » Wed Feb 17, 2021 1:55 pm

Managed to get this thing working on the first try (although I may or may not have melted the midi controller the first time and had to order a replacement). Started by covering this thing in many layers of polyurethane but after reading a few other posts I decided to just wrap the thing in electrical tape. First layer over the secondary. Then another layer of the primary

Thank you for the great project


Test one - Atenna was too close
Test two - In the dark
jeebwise
Tipsy Toggle Switch
 
Posts: 1
Joined: Wed Feb 17, 2021 1:47 pm

Return to Completed oneTesla Kits

Who is online

Users browsing this forum: No registered users and 4 guests