Managed to get this thing working on the first try (although I may or may not have melted the midi controller the first time and had to order a replacement). Started by covering this thing in many layers of polyurethane but after reading a few other posts I decided to just wrap the thing in electrical tape. First layer over the secondary. Then another layer of the primary
Thank you for the great project
Test one - Atenna was too close
Test two - In the dark
- It is currently Wed Oct 09, 2024 2:49 pm • All times are UTC - 5 hours
Success - TinyTesla
1 post
• Page 1 of 1
1 post
• Page 1 of 1
Return to Completed oneTesla Kits
Who is online
Users browsing this forum: No registered users and 2 guests