gen 1 interrupter

Non-kit projects based on the public Gen1 designs

gen 1 interrupter

Postby SimonWHVUK » Sat Jun 06, 2020 2:03 pm

Hi My name is Simon from the UK

I hope someone can help :-)
I've built the gen 1 interrupter and have an issue with the output in fixed mode,the signal which is coming from the output (from Pin 4 of chip) is jumping a few us and does this regardless of the PW or Frequency pot position. I've checked my circuit and wiring I've programmed 2 different chips so 3 in total and all have the same problem.

here is a video link of my circuit: https://www.youtube.com/watch?v=KqAb0Yklx74
hope this helps

I'm not to good with Arduino code but can figure it out if i know what to look for so if someone can point me in the right direction i mite be able to fix this pw jumping issue.
also were in the code do i need to adjust to increase the frequency bps from 200Hz/300Hz to say 20Hz to 600Hz?

Thanks for your time and hopefully help ;-)

Simon, UK
SimonWHVUK
Tipsy Toggle Switch
 
Posts: 2
Joined: Sat Jan 04, 2020 8:40 am

Return to Independent Gen1 Builds

Who is online

Users browsing this forum: No registered users and 3 guests