Hi Im Simon From the uk
First of all vie got a TS and its working Great good job guys!
Now i wonder if you guys could help I've built the Midi interrupter (NOT SD) which i plan on using on a coil I've designed and run into a problem, The output waveform from the atmega pin 4 is not stable it seems to be randomly jumping a few us this is happening through the whole range from 9us to 97us? ive programmed 2 atmega's and both have the same problem I've checked the 16mhz crystal its nice and stable voltage is nice and stable so only conclusion is maybe something to do with the code?
pic attached from the scope to see what i mean
unfortunately i'm not that familiar with code but have done a little arduino here and there so can work things out with a little help and pointed in the right direction
also were in the code do i need to change so can the frequency be adjusted say 5 hz to 1khz? if possible?
hope you can help and
Thanks for your help
Simon, UK
- It is currently Sun Oct 13, 2024 5:44 am • All times are UTC - 5 hours
Interrupter (Not SD Interrupter!)
1 post
• Page 1 of 1
Interrupter (Not SD Interrupter!)
- Attachments
-
- pwjumping2.jpg
- pwjumping
- (986.1 KiB) Not downloaded yet
- SimonWHVUK
- Tipsy Toggle Switch
- Posts: 2
- Joined: Sat Jan 04, 2020 8:40 am
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest