![Image](http://www.arttec.net/OneTesla_fixes/Main_chassis_assm%20(1).jpg)
Clearly a design revision is in order for the laser cut acrylic, and a smaller screw terminal block should be used in future.
My solution was to use my large upright belt sander to grind off about 1/8" off the rear surface of the screw terminal block:
![Image](http://www.arttec.net/OneTesla_fixes/Main_chassis_assm%20(2).jpg)
The other issue is that the hole in the rear chassis panel does not align with the screw terminal block. I had to mill out the aperture so that it would align sufficiently to allow connections to the screw terminals:
![Image](http://www.arttec.net/OneTesla_fixes/Main_chassis_assm%20(3).jpg)
This aperture should be moved over to align correctly with the screw terminal block in a future revision.